Ottoseal A710 white 310 ml cartridge – case of 20

The case of 20 is the manufacturer’s original case containing 20 units of the same type. You pay less per unit than when buying singly, and the sealed case is delivered – ideal for trade businesses and larger projects.

Ottoseal A710 special acrylic sealant for RAL installation INTERIOR. Ottoseal A 710 has a high practical movement capability and has a low water vapour permeability and therefore Ottoseal A710 RAL Installation INTERIOR is perfectly suited to a permanent airtight interior seal. Ottoseal A710 RAL Installation INTERIOR is used in a system with the OTTO sealants OTTOSEAL P 720 / OTTOSEAL S 730 (exterior sealing).

• Acrylate sealant for RAL installation INTERIOR 
• Low water vapour permeability
• For permanent airtight sealing
• High practical movement capability
• Outstanding workability
• Very good paint compatibility according to DIN 52452

Areas of application:

• For RAL installation INTERIOR
• For the permanent airtight interior sealing of connection joints between window and building structure.
• Can be used in a system with the OTTO sealants OTTOSEAL P 720 / OTTOSEAL S 730 (exterior sealing)

Pre-treatment:

The bonding surfaces must be clean, free of dust and grease and sound. The bonding surfaces must be cleaned and any contamination, such as release agents, preservatives, grease, oil, dust, water, old adhesives/sealants and other substances that impair adhesion, must be removed. Cleaning non-porous substrates: clean with OTTO Cleaner T (flash-off time approx. 1 minute) and a clean, lint-free cloth. Cleaning porous substrates: clean surfaces of loose particles mechanically, e.g. with a steel brush or a grinding disc. Absorbent mineral bonding surfaces should be dampened with water to improve adhesion. The following are also available to improve adhesion: on absorbent substrates - mixture of acrylic sealant/water 1:2 - on absorbent and non-absorbent substrates: primer

Application notes:

Apply the sealant evenly with a manual caulking gun, compressed-air gun or cordless gun and press the surface down with a dampened tool before a skin begins to form. Remove contamination with water while it is fresh. Because of the many possible influences during processing and application, the applicator must always carry out a trial application. The specific use-by date can be found printed on the container and must be observed. We recommend storing the adhesives / sealants in the unopened original containers dry (< 60 % RH) in a temperature range of + 15° C to + 25° C. If the products are stored and/or transported for longer periods (several weeks) at higher temperature/humidity, a reduction in shelf life or a change in material properties cannot be ruled out.

Standards and tests:

• Component test “Air permeability and driving-rain tightness of a sealing system between window and building structure after simulated short-term loads” (ift Rosenheim)
• “Recommended for healthy living” by the German Committee for Residential Medicine and Building Hygiene
• Suitable for applications in accordance with IVD leaflet no. 9

Supplied as:

310ml PE cartridge (20 cartridges per carton)

Colour:

white