Skip to main content Skip to search Skip to main navigation

DENSO TOK-Band SK N2 self-adhesive bitumen joint tape for low temperatures

Description

DENSO TOK-Band SK N2 is a self-adhesive bitumen joint tape made from polymer-modified road bitumen, for sealing joints and seams in asphalt road construction at low temperatures. It stays flexible and workable where conventional bitumen joint tapes are already too stiff.

Benefits at a glance

  • Can be applied from 0 degrees Celsius, so it can also be used in the cold season
  • In the system with TOK-SK Primer, elongation of at least 33 per cent is achieved at minus 10 degrees Celsius
  • Fitted on one side with a homogeneous adhesive layer over the full surface, fixed cold to the joint face
  • No primer needed as long as the face has been properly cleaned and is dust-free and dry
  • Meets all requirements of ZTV Fug-StB 15

Areas of application

  • Joints and seams in asphalt road construction with increased demands on adhesion and elongation
  • Connections with larger movements, such as at rails and fixtures
  • Construction sites in the cold season where the time window would otherwise not be sufficient
  • Longitudinal and transverse seams when laying rolled asphalt and mastic asphalt

Limits & notes

The application temperature is between 0 and +35 degrees Celsius, which is lower than for TOK-Band SK. Above +35 degrees Celsius, TOK-Band SK is the right choice. Under ZTV Fug-StB, bitumen joint tapes may only be installed in dry weather. The minimum tape width is 10 millimetres. Rust, loose particles and moisture on the abutting face prevent adhesion.

Application & tips

Lay out the tape with the smooth adhesive layer facing up against the prepared face and remove the release paper only immediately before laying. Then press the adhesive layer firmly against the abutting face by hand or with an auxiliary tool. The slightly wavy side stays exposed; the hot mix is later built up against it. On rolled asphalt surface courses, lay with a 5 millimetre overhang; on mastic asphalt surfaces, install flush. For the extreme elongation values in frost, the tape is applied in the system with the TOK-SK Primer. Store rolls dry, without load and frost-free, ideally at 15 to 20 degrees Celsius.

Technical data

Area of use: Exterior
Content: 1200 m
Material: Bitumen
Pack size: 1200 m pallet
Version
Size: 30 x 10 mm
Technical data
Base: Polymer-modified road bitumen
Softening point (ring and ball): above +100 °C (requirement above +90 °C)
Cone penetration: 20 to 50 (0.1 mm)
Elastic recovery: 10 to 30 %
Elongation and adhesion: at least 10 % / at most 1.0 N/mm²
Elongation at -10 °C: at least 33 % in the system with TOK-SK Primer
Standards: ZTV Fug-StB 15, tested to TL/TP Fug-StB
Application
Application temperature: 0 °C to +35 °C
Pre-coat: not required, TOK-SK Primer for frost elongation values
Storage: dry, without load, frost-free, ideally 15 to 20 °C, shelf life at least 2 years
Use
Tape overhang: 5 mm for rolled asphalt, flush for mastic asphalt
What's included
Supplied as: 1200 m pallet with 30 cartons of 40 m each

Frequently asked questions

What is the difference between TOK-Band SK N2 and TOK-Band SK?

SK N2 stays flexible in the cold and is applied from 0 to +35 degrees Celsius, SK from +5 to +50 degrees. For warm days, SK is the better choice.

How stretchable is the tape in frost?

In the system with TOK-SK Primer, elongation of at least 33 per cent is achieved at minus 10 degrees Celsius.

Do I need a primer coat?

Not for normal installation; the face only has to be clean, dust-free and dry. For the extreme elongation values in frost, TOK-SK Primer is used.

How many metres does a pallet contain?

A Euro pallet always holds 30 cartons. With the 30 x 10 mm profile that is 1200 metres, with the 40 x 10 mm profile 900 metres.

How long can TOK-Band SK N2 be stored?

Stored dry, without load and frost-free, for at least two years from the date of manufacture in the unopened original packaging.

Manufacturer information

Manufacturer information pursuant to Art. 19 EU GPSR

Postal address DENSO GmbH
Felderstraße 24
51371 Leverkusen
Germany

Electronic address info@denso-group.com

All products by DENSO

Information as of: 2026-11-08

Reviews

0 of 0 reviews

Average rating of 0 out of 5 stars

All reviews come from buyers. Reviews can only be submitted via the personal, signed link we send to the order's e-mail address after delivery; the link is bound to the order and the purchased item, there is no form without a purchase. We check every review before publication and publish positive and negative reviews alike. Reviews from our former shop baustoffhandel-nrw.de were migrated; there, too, only customers who had bought the item could review it.